Engine

Engine Overhaul Kit to suit John Deere 2850

Consists of; 4 x Cylinder Kit 1 x Complete Gasket Set 1 x Front Crank Seal (59mm x 76.5mm x 10mm) 1 x Rear Crank Seal (118mm x 146.1mm x 12.7mm) 4 x Small End Bush- 41mm Piston Pin 2 x Cylinder Head Stud (Pack Of 9)

Crankshaft (Genmot) to suit John Deere 2850

Long Nose For Tractors With Hydraulic Pump Driven Off Crank

Crankshaft for John Deere 2850

Short Nose for Tractors without Crank Driven Hydraulic Pump.

Mains: 3.1235"/3.124"
Conrods: 2.7485"/2.749"
Stroke: 4.330"
Lip Seal
Holes: 4+1
Keyed

*NOTE - Prior to fitting, crankshaft will require cleaning to remove any rust preventative*

Flanged Bearing With Intergrated Thrust to suit John Deere 2850 Tractors

Conrod Bearing (Pair) Std, to suit John Deere 2850 Tractors

Product is 1 Pair of Shells, For 3 Cylinder Order 3 Pairs For 4 Cylinder Order 4 Pairs For 6 Cylinder Order 6 Pairs

Conrod Bearing (Pair) +0.010", to suit John Deere 2850 Tractors

Product is 1 Pair of Shells, For 3 Cylinder Order 3 Pairs For 4 Cylinder Order 4 Pairs For 6 Cylinder Order 6 Pairs

Conrod Bearing (Pair) +0.020", to suit John Deere 2850 Tractors

Product is 1 Pair of Shells, For 3 Cylinder Order 3 Pairs For 4 Cylinder Order 4 Pairs For 6 Cylinder Order 6 Pairs

Conrod Bearing (Pair) +0.030", to suit John Deere 2850 Tractors

Product is 1 Pair of Shells, For 3 Cylinder Order 3 Pairs For 4 Cylinder Order 4 Pairs For 6 Cylinder Order 6 Pairs

Valve Train Kit Ti Fit John Deere 2850
Consists of 4x Inlet Valve, 4x Exhaust Valve, 8x Valve Spring, 8x Valve Stem Cap

Turbocharger to suit John Deere 2850

Cylinder Head Bolt (Set of 9) To Suit John Deere 2850 Tractors

Head Gasket Set to suit John Deere 2850

Head Gasket to suit John Deere 2850

Oil Filter To Suit John Deere 2650 Tractors

Front Seal To Fit John Deere 2850 Tractors